Manual

PROBLEM SOLUTION
There is picture or sound
interference with the TV
reception.
•_During playback via the internal TV tuner (MONITOR button), switch to recording mode
'M1' by pressing REC MODE. This will give you the best possible picture quality.
Before making the recording, select the recording mode as described in chapter 'Manual
recording', section 'Selecting the recording mode (quality)'.
•_Change the modulator channel. During standby hold on the remote the button 3 pressed to
switch to channel 3. With button 4 you switch to channel 4.
•_Have your antenna or cable TV signal checked
The picture is distorted or
black-and-white during
playback.
•_The TV system of the disc does not match that of your TV (PAL/NTSC).
€The recording can be made in color only when the TV channels or the connected additional
device sends a color signal. Black-and-white signals without color information (color
subcarriers) cannot be recorded in color.
A DVD+RW cannot be
played on certain DVD
players
•_lf a recording is too short, it is possible that a DVD player cannot detect it: Please observe
the following 'Minimum recording times':
Recording mode 'MI': 5 minutes, 'M2': ]0 minutes, 'M2x': ]3 minutes, 'M._: 15 minutes, 'M4':
20 minutes 'M6': 30 minutes 'M8': 30 minutes
•_Some DVD players cannot playback DVD+RW recordings. You can solve this problem by
using a special function:
1 Open the disc tray with OPEN/CLOSE A . Insert the disc but do not close the
tray.
2 Hold down the number button 2 on the remote control until the tray closes The
disc is modified.
3 If this fails to produce the desired result, repeat the procedure using the number
button 3 on the remote control
4 You can restore the disc to its original condition by pressing and holding 1 .
Warning!
There is a risk that you can no longer play the disc on other DVD players after this
procedure. Therefore, apply this function with particular care.
Before you call technical support 99