Owner`s manual

Refer to the table below when this unit does not functiou properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn offthis unit, disconnect the power cable, and contact the nearest attthorized
Yamaha dealer or service center.
• General
This unit fails to turn The power cable is not connected or the Connect tile power cable firmly.
on or enters the plug is not completely inserted.
standby mode soon
after the power is The speaker impedance setting is Set the speaker impedance to match your speakers. 25
turned on. incorrect.
The protection circuitry has been Make sure that all speaker wire connections on tiffs 13
activated, unit and on all speakers are secure and that the wires
for each connection do not touch anything other than
their respective connections.
Tiffs unit has been exposed to a strong Sol this unit to the standby mode, disconnect the
external electric shock (such as ligbming power cable, plug it back in after 30 seconds and then
or strong static electricity), use this unit nommlly.
No sound. Incorrect input or output cable Connect the cables properly. If the problem persists, 18=23
connections, the cables may be def,:ctive.
The optimizer microphone is connected. Disconnect the optimizer microphone. 31
Audio input jack select is set to "HDMI', Set Audio input jack select to "AUTO". 39
"COAX/OPT" or "ANALOG".
Audio input jack select is set to SO Audio input jack select to "AUTO" or 39
"ANALOG" while playing a source "COAX/OPT'.
encoded in Dolby Digital or DTS.
No appropriate input source has been Select an appropriate input source with the INPUT 37.38
selected, selector on the front panel (or tile input selector
buttons on tile remote control).
Speaker connections are not secure. Secure the connections. 13
The front speakers to be used have not Select the front speakers by pressing I_SPEAKERS 38
been selected properly, on the front panel repeatedly.
The volume is turned down. Turn up the volmne.
The sound is muted. Press @ MUTE or @VOLUME +/- on the remote 40
control to resume audio output and then a{ljustthe
vo]ullle.
Signals dfis unit cannot reproduce are Play a source whose signals can be reproduced by this
being input from a source component, unit.
such as a CD-ROM.
The HDMI components connected to this Connect HDMI components that support the HDCP 16
unit do not SUl)portthe HDCP copy copy protection standards.
protection standards.
"SUPPORT AUDIO" is set to "OTHER" Set "SUPPORT AUDIO" to "RX-V861" in 77
and "HDMI" audio signals are not being "MANUAL SETUP".
played back on this unit.
No picture. The output and input R_rthe picture are Set "V CONV." to "ON" or connect your source 82
connected to difl_:rvnt types of video components in the same way as you connect your
jacks, video monitor to this unit.
Non-standard video signals are input.
97 En