Owner`s manual

fP_qmf{q'a_ff_'
• XM Satellite Radio
If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel
display. In this case, read the cause and follow the corresponding remedies.
,"q...ii::r,"g...',"lM"i"i::ri..iM,"l The XM Mini-Tuner and X_ Dock are Check XM Mini-Tuner and XM Dock connections 53
L,.,I IL,,,L,.,I',, r'_l ,i i L,,A _I 'ir'_
nol connected to the XM jack of Ihis unit and orienl for the best reception level.
or do not work properly,.
,...,_ii_:::,i".."_Ti..."r'., i .H".-..aTi..h'::: The XM tlser encrvption, code is bein_ Wait tllltil tile encr'vption, code is tlpdated.
updated.
i".-...,i"i;"l...,.i.,...ll".,m.,.<:7T ¢:si..i;"li.... The signal is to() weak. A_{just Ihe orienlalion of Ihe XM Mini-Tuner for Ihe 53
besl receplion level.
_....,...,r'.q...'i_"."_r.,a.T_i"ig":'...a It takes lon_er_ Ihan four seconds lkw audio Wait until the decoding process has finished.
or lext data Io be decoded.
,'%::'i::r _",'r i:::, Tile XM Salellite Radio channel VOLI Check Ihe channel number again or selecl anofller
L,.ll 1 I"I ,L I%
selecled is nol currenlly broadcasting any XM Satellile Radio channel.
signals.
...'...=...=...,i.,_...,................. The Channel St alion [D (SID) is no longer
available.
............... .." -.............. No artisl name or song litle is available.
"'...,....r".,_"'¢"_"r_"..................... No channels are available for Ihe selected Select anolher channel category by pressing 55
calegory. @CATEGORY on the fronl panel (or @A-E/CAT.
< / C> on Ihe remote control repeatedly.
• Remote control
The remote control Wrong dislance or angle. The remote comrol will function within a maximulil 27
does not work or range of 6 m (2(1 El) and no more Ihan 30 degrees off-
function properly, axis from the l¥ont panel.
Direct sunlighl or lighting (from an Reposition this unit.
inverler lype of fluorescent lamp, elc.) is
slriking Ihe remote control sensor of Ihis
unil.
The batteries are weak. Replace all batteries.
The operation mode selector is sel Set Ihe operalion mode selector correctly,.
incorrectly. When operating this unil, set it to Ihe @AMP
position.
When operating the component selecled by, the inpul
selector bulton, set il Io the @SOURCE position.
When operaling Ihe TV sel in tile DTV or PHONO
area, set il Io the @TV position.
Set Ihe remote control code correclly using "List of
remole control codes" al the end of this manual.
The relTIOte control code was nol correcl]y
set.
Try selting anolher code of the same manufacturer
using "List of remote conlrol codes" al the end of Ihis
mal/tlal.
88
88
The ID code of Ihe remote conlro] and Ihe Malch Ihe remole control ID of this unil with the 94
remole conlrol ID of Ihis unit do not corresponding relnole conlrol ID code.
ITlalch.
101 En