Owner`s manual

Be sure to connect the left channel (L), right channel (R), "+" (red) and .... (black) properly. If the connections are faulty,
this unit cannot reproduce the input sources accurately.
Caution
• Before connecting the speakers, make sure that this unit is turned off (see page 25).
• Do not let the bare speaker wires touch each other or let them touch any metal part of this unit. This coukt damage
this unit and/or the speakers. If the speaker wires are short-circuited, "CHECK SP WIRES" appears in the front
panel display when you turn on this unit.
• Use the magnetically shielded speakers. If this type of speaker still creates interference with the monitor, place the
speakers away from the monitor.
• If you are to use 6 ohm speakers, be sure to set "SP IMR" to "6f.) MIN" before using this unit (see page 25). 4 ohm
speakers can be also used as the front speakers (see page 94).
A speaker c®rd is actually a pail" of insulated cables running side by side. Cables are col®red ®r shaped differenlly, perhaps with a stripe,
gr®®veor ridge. C®nnecl the striped (gro®ved, etc.) cable Il! the "+" (red) terminals ®f Ihis unit and your speaker. Connect the plain cable
t®the .... (black) terminals.
EXTRA SP terminals
Connect the alternative li'ont speaker system (FRONT B), presence speakers or Zone 2 speakers.
To select the Rmction of the speakers connected to the EXTRA SP terminals, set the "EXTRA SP
ASSIGN" parameter ill "SOUND MENU" (see page 72).
-"4;'-
You call also select the function of the speakers connected to the EXTRA SP terminals in "AUTO
SETUP" (see page 29).
Subwoofer
Right Left
Front speakers
(FRONT A)
Center ea er
Right Left
Surround speakers
Right Left
Surround back speakers
When you use a single surround back
speaker,c®nnectthe speaker to the lell
SURROUND BACKterminal
(SINGLE).
13 En