Owner`s manual

,qfff_f|qf_
Caution
If you are to use 6 ohm speakers, set "SP IMR" to
"6f2 MIN" as follows BEFORE using this unit. 4 ohm
speakers can be also used as the front speakers.
1 Make sure this unit is turned off.
Refer to the right colunm for details.
2 Press and hold @TONE CONTROL on the
front panel and then press @MASTER ON/
OFF inward to the ON position to turn on this
unit.
This unit turns on, and tile advanced setup menu
appears in the front panel display.
3
TO.ECOmROL While holding MASWR
down ,_% -
o
Rotate the @PROGRAM selector on the
front panel to select "SP IMP.".
"SP IMP." and the current speaker impedance setting
("8f.) MIN') appear in the front panel display.
4 Press @TONE CONTROL on the front
panel repeatedly to select "6f_ MIN".
5 Press @MASTER ON/OFF on the front
panel to release it outward to the OFF
position to save the new setting and turn off
this unit.
Note
The setting you made is reflected next time yon turn on this
unit.
• Turning on this unit
Press @MASTER ON/OFF on the front panel
inward to the ON position to turn on this unit.
When yon turns on this unit by pressing @MASTER
ON/OFF, the main zone is turned on.
When you turn oi/this unit. there will be a 4 to 5_second delay
belk_rethis unit can reproduce sound.
• Turning off this unit
Press @MASTER ON/OFF on the front panel
again to release it outward to the OFF position to
turn off this unit.
• @MAIN ZONE ON/OFF on the front panel as well as
@POWER and (_)STANDBY oi/the remote control are
operational only when @MASTER ON/OFF is pressed
inward to the ON position.
• Basically, we recommend that you use the standby mode to turn
olT this unit.
• Set the main zone to the standby mode
Press @MAIN ZONE ON/OFF (or @STANDBY)
to set the main zone to the standby mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
• Turning on the main zone from the
standby mode
Press @MAIN ZONE ON/OFF (or @POWER) to
turn on the main zone.
• You can also turn on the main zone by pressing _SCENE (or
@SCENE) buttons.
• When you turn on this unit. there will be a 4 to 5-second delay
before this unit can reproduce sound.
• These buttons are operational only when @ MASTER ON/
OFF is pressed inward to the ON position.
25 En