Owner`s manual

Beli)reperlorming the followingoperations, set the operatiun
modeselector on the remote contrul tu @SOURCE.
• All Channel Search mode
1 Press _SEARCH MODE (or (_SRCH
MODE) repeatedly to select "ALL CH
SEARCH".
2 Press _PRESET/TUNING/CH <1/_> (or
@PRESET/CH /_ / V) repeatedly to search
for a channel within all channels.
• Youcan search for a chanuel quickly by pressing and
holding @PRESET/rUNING/CH <3 / ;:> (or
_)PRESET/CH A / V).
• To display the XM RadiuID number displayed in theflout
pane]display, selectchannel "0".
• Category Search mode
1 Press _SEARCH MODE (or _)SRCH
MODE) repeatedly to select "CAT SEARCH".
2 Press _CATEGORY (or (_A-E/CAT. <1 / _:>)
repeatedly to change the channel category.
3 Press (_PRESET/TUNING/CH <1/_:> (or
@PRESET/CH /_ / V) repeatedly to search
for a channel within the selected channel
category.
-#-
Youcan search for a channel quickly by pressing and
holding @PNESET/TLINING/CH <:3/ ;:>on the front
panel (ur @PRESET/CH A / g on the remotecontrol).
• Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see "Setting the XM Satellite Radio preset
channels" on page 56.
_-,#-
Theinitial factory setting of all preset channels (AI to E8) is
"[001] Preview".
1 Press _SEARCH MODE (or _SRCH
MODE) repeatedly to select "PRESET
SEARCH".
2 Press @CATEGORY (or @A-E/CAT. <1 / _)
repeatedly to change the preset channel
group (A to E).
1
Press _PRESET/TUNING/CH <1 / L> (or
@PRESET/CH A / _) repeatedly to change
the preset channel number (1 to 8).
_%,._
Youcan alsoselect thepreset channel number directly by
pressing the numeric buttons (1to 8) (1_)).
Direct number access mode
Press (_SRCH MODE on the remote control
repeatedly to select "ALL CH SEARCH" or
"CAT SEARCH".
Press the numeric buttons (®) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons ((_)) as shown below.
ENTERTAIN
CLASSICAL L_/_CLUB
%-%-%
The display changes as follows.
.<>:iHi::...... i 2
.' z : _. a ', a ,,% '-z,
':..=:':,i'i ..:'i .=::i,3
• To enter a one<ligit or two-digitchannel number, press the
numeric buttons((_))on the remote control and then press
@ENT tu confirm the input number.
• Insteadof pressing (_)ENT to tuneinto thechannel
immediately,you can wait a li:w secunds until this unit
confirms the entered channel number.
• If nubutton is pressed within a li:w seconds afteryou enter
a one-digit or two-digit number, this unit automatically
confirms the entered channel number.
• Pressinga button other than the numeric buttons ((_) or
@ENT cancels the DirectNumber Access mode
procedure.
55 En