Owner's Manual

ManualsBrandsMAGNAVOX ManualsAudio EquipmentMini Wireless Stereo Earphone With Bluetooth Wireless Technology

1. Bouton

2. Port Micro USB

(pour chargement uniquement)

3. Voyants LED

4. Connecteur AUX (In)

5. Microphone

6. Bouton

7. Bouton

英

POWER SOURCE

OPERATION

31 2

1. Button

2. Micro USB Port (For Charging Only)

3. LED Indicators

4. AUX (In) Jack

5. Microphone

6. Button

7. Button

The unit has a built-in Li-ion rechargeable battery, charge it before first time use or when it is

drained as follows:

1. Connect the small plug from the supplied USB Connection Cable to the Micro USB Port.

2. Connect the full size USB Plug from the supplied USB Connection Cable to the USB Port

on the Personal Computer or USB Charger (Computer and USB Charger not included).

3. When charging, the Red Charging Indicator on the unit will illuminate.When charging is

complete, the indicator will turn off.

NOTES:

Your battery will last longer if you following these simple guidelines for caring and storing:

A. Before first time use, recharge the unit approximately 4 hours until the unit is fully charged.

B. Charge and store the unit within the temperature range of 5°C - 35°C (40°F - 95°F).

C. Do not overcharge (longer than 24 hours). Excessive charging or running the unit until

battery fully drains will damage battery. Battery life will be extended if you keep the battery

fully charged.

D. Battery life naturally shortens slowly over time.

E. The rechargeable battery incorporated in this product is not user replaceable.

For first time use or re-pairing the unit to a new BT Device, pairing it as

below:

1. Press and holding the Button approximately 2 seconds to power on the unit. The

Blue & Red Indicators will illuminate & blink.

2. Power on the external BT Device and enter to BT searching mode. Start pairing following

the on screen instructions from the external BT Device. When paired, the Blue LED

Indicator will stop blinking and Red LED Indicator will turn off.

3. If pairing is complete you may now play music and answer the phone with your external

BT Device.

LOCATION OF CONTROLS

Reduce the volume level by press

Increase the volume by

TROUBLESHOOTING

4 5 6

4. During playback:

The Blue LED Indicator will start blinking.

Press the Button to pause; press again to resume normal playback.

Press and release the or Buttons to adjust volume level as desired.

Press and hold the or Buttons repeatedly to skip tracks.

5. If the unit is paired to a Cell Phone and a call is incoming during an active music session:

Press the Button then speak to the Microphone to answer the call. When your call

is complete, press the Button to disconnect or end the call and resume to music

playback.

Or, press and holding the Button approximately 1 second to decline the incoming

call then resume to music playback.

6. When finish listening,press and holding the Button approximately 3 seconds until the

Blue Indicator not light.

Notes:

When the external BT Device searched the unit, our model number “MBH542” will

appear on the display of external BT Device.

If while pairing you are asked for a code please try "0000" or "1234".

Normal operation after paired:

1. Power on the external BT Device and enter to BT mode.

2. Press and holding the Button approximately 2 seconds to power on the unit. The

Blue & Red Indicators will illuminate & blink.

3. Wait a few seconds until the unit automatically pair to the BT Device. When paired, the

Blue LED Indicator will stop blinking and Red LED Indicator will turn off.

4. If pairing is complete you may now play music and answer the phone with your external

BT Device.

AUX (In):

Listen music through the Aux Out; Line Out or Phone Jack from external

audio player:

1. In power off mode, connect one end of the supplied Audio Connection Cable to the

AUX (In) Jack on the unit.

2. Connect the other end to the Aux Out; Line Out or Phone Jack on external audio player.

3. Play the music on the external audio player as usual.

4. Use the Volume controls on the external audio player to adjust volume level as desired.

Note: If the Audio Connection Cable is inserted into the AUX (In) Jack, BT

will be automatically shut off. Unplug the cable from the jack before use BT.

Check the following before requesting service:

SYMPTOM POSSIBLE CAUSE POSSIBLE SOLUTION

Can't power on Built-in battery drained Recharge the battery as page 3

No sound or

sound weak

Volume of the unit was set to minimum

position

press and

release the Button on the unit

Volume level of paired/connected device is

in low level

Rise the volume level of the

paired/connected device

Sound

distortion

Volume level too high

and release th e Button on the

Volume level of the

pair

ed/connecteddevice too high

Reduce the volume level of the

paired/connected devic e

BT not

functioning

The external BT device had NOT paired to

the unit

Pair the external BT device to the

unit as page 3-4

The external BT device too far from the

unit

Place the external B T device close

to the unit

Audio Connection Cable was inserted into

the AUX (In) Jack

Unplug the Audio Connection Cable

from the AUX (In) Jack before use

unit

Power source: Built-in DC 3.7V, 200 mAh (0.74 WH) rechargeable Li-ion

Battery, Recharge by DC 5V through the Micro USB Port

Impedance of the Earbuds: 32ё per Channel

Audio power: 10 mW per Channel (Total 20mW)

BT Version: V4.1+EDR

BT Operation Distance: 32 Feet in open area

1 x Owner’s Manual

1 x USB Connection Cable (For Charging only)

1 x Audio Connection Cable with 3.5 mm plugs

SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT

NOTICE

GENERAL SPECIFICATIONS:

PACKAGE INCLUDES:

Emplacement des commandes

31 2

法

SOURCE D'ALIMENTATION

INFORMATION de la Commission des Communications Fédérales:

AVIS de la Commission des Communications Fédérales:

FONCTIONNEMENT

Remarques:

DIAGNOSTIC DES ANOMALIES

4 5 6

CARACTÉRISTIQUES GÉNÉRALES:

L’EMBALLAGE COMPREND:

Remarques:

Utilisation normale après jumelage:

AUX (In):

Ubicación de los controles

31 2

西

1. Botón

2. Puerto micro USB (solo para cargar)

3. Indicadores LED

4. Entrada AUX

5. Micrófono

6. Botón

7. Botón

FUENTE DE ALIMENTACIÓN

INFORMACIÓN DE LA FCC:

AVISO DE LA FCC:

NOTAS:

OPERACIÓN

SOLUCIÓN DE PROBLEMAS

4 5 6

ESPECIFICACIONES GENERALES:

PAQUETE INCLUYE:

Notas:

Funcionamiento normal después de emparejamiento:

AUX (Entrada):

200

0.74

200 0.74

release

Summary of content (2 pages)

PAGE 1
POWER SOURCE LOCATION OF CONTROLS The unit has a built-in Li-ion rechargeable battery, charge it before first time use or when it is drained as follows: 1. Connect the small plug from the supplied USB Connection Cable to the Micro USB Port. 2. Connect the full size USB Plug from the supplied USB Connection Cable to the USB Port on the Personal Computer or USB Charger (Computer and USB Charger not included). 3. When charging, the Red Charging Indicator on the unit will illuminate.
PAGE 2
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.