This equipment should be installed and operated with a minumum distance of 20 cm between the radiator and your body.
PREPARATION FOR USE 6
CARE AND MAINTENANCE 7
LOCATION OF CONTROLS 1. FM Telescope Antenna 2. Carry Handle 3. VOLUME Control Knob 4. Decorative LED Blinking Mode Selection (Turn Off) Button 5. M (Memory) Button 6. ■/BAND (Stop/Radio Band Selection) Button 7. 8. (Skip/Fast Search Backward) Button (Skip/Fast Search Forward) Button 9. /SCAN (Play - Pause/Radio Scan) Button 10. BT/CD (Bluetooth/CD Mode Selection) Button 11. CD Door 12. FINE TUNE (Radio Fine Tune) Knob 13. CD Door OPEN/CLOSE Area 14. POWER Indicator 15. LCD Display 16.
OPERATION RADIO: 1. Slide the Function Selector to RADIO position to turn on the radio. 2. Press the ■/BAND Button repeatedly to select AM or FM band as desire. The correspondence indicator AM or FM and the radio frequency will appear on the LCD Display. 3. Press and hold the /SCAN button until the radio frequency on the LCD Display starts running to automatically search and will store the channel in PROG. 4. Press and hold the or Buttons play the previous/next available radio station.
CD: 1.Slide the Function Selector to BT/CD/AUX position to turn on the CD. The LCD Display will illuminate and indicator “CD” will appear. 2.Press the OPEN/CLOSE Area on the CD Door to open it then place a CD disc on the center spindle, with the printed side face up. 3.Close the CD door by pressing the OPEN/CLOSE area. Wait a few seconds; the number of the total tracks will appear on the LCD Display. 4.Press the /SCAN Button to start playing the first track on the disc. 5.
LCD Display. All the tracks on the current disc (or program) will be playback repeatedly. 3. During playback, press the M Button three times, the random indicator "RAND" will appear on the LCD Display. The unit will play the tracks randomly. 4. To cancel the repeat and random play functions, press the M Button repeatedly until all repeat/random playback indicators disappear on the LCD Display or press the ■/BAND Button to stop playback. Note: Random playback is not available in program playback mode.
•Indicate “bt” will appear on the LCD Display and blink. 3. Wait a few seconds until the unit is automatically paired to the external BT Device. The indicate “bt” on the LCD Display and Indicator on the front of unit will stop blinking. 4. After pairing is complete you may now play music with your external BT Device. AUX (in): 1. Insert one end of the Audio Connect Cable (not included) to the AUX Out; Line Out or Phones Jack on the external Audio Player. 2.
TROUBLESHOOTING Check the following before requesting service: SYMPTOM POSSIBLE CAUSE AC Power cord had not connected No power POSSIBLE SOLUTION Connect the AC Cord to the rear of unit and any wall outlet having AC 120V~; 60Hz Volume of the unit was set to minimum Increase the volume level by turning the position VOLUME Control Knob clockwise No sound or sound weak Volume level of paired/connected Rise the volume level of the device is in low level paired/connected device Volume level too high
