Installation Instructions

13
TROUBLESHOOTING
Check the following before requesting service:
SYMPTOM
POSSIBLE CAUSE
POSSIBLE SOLUTION
No power
AC Power cord had not connected
Connect the AC Cord to the rear of unit and
any wall outlet having AC 120V~; 60Hz
No sound or sound weak
Volume of the unit was set to minimum
position
Increase the volume level by turning the
VOLUME Control Knob clockwise
Volume level of paired/connected
device is in low level
Rise the volume level of the
paired/connected device
Sound distortion
Volume level too high
Reduce the volume level by turning the
VOLUME Control Knob counterclockwise
Volume level of the connected/paired device
too high
Reduce the volume level of the
connected/paired device
CD or BT not functioning
Audio Connection Cable was
inserted into the AUX (In) Jack
Unplug the cable from AUX (In) Jack
BT not functioning
The external BT Device had NOT paired to
the unit
Pair the external BT Device to the unit as
page 11-12
The external BT Device too far from the unit
Place the external BT device close to the
unit
CD not play
Disc is dirty or scratched
Try other discs
CD disc incorrect install
Place the CD disc on the center spindle
with label side face up
CD compartment door is not closed.
Close CD door completely.
GENERAL SPECIFICATIONS
Power Source: AC 120 V~; 60 Hz; 16 W, Or
DC 12 V; 8 x “C” size batteries (Not included)
BT Version: 5.0
BT Operation Distance: 32 Feet in open area
Radio Frequency: AM: 520-1710 kHz ;
FM: 87.5-108 MHz
Disc Compatible: CD; CD-R; CD-RW
Impedance of Speakers: 2 x 3 W; 4 ohm
Audio power: 2 W per Channel (Total 4W, RMS)
ACCESSORIES
1 x Owner’s Manual
1 x AC Power Cord
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE