Installation Instructions

OPERATION

RADIO:

1. Slide the Function Selector to RADIO position to turn on the radio.

2. Press the ■/BAND Button repeatedly to select AM or FM band as desire. The correspondence

indicator AM or FM and the radio frequency will appear on the LCD Display.

3. Press and hold the /SCAN button until the radio frequency on the LCD Display starts running to

automatically search and will store the channel in PROG.

4. Press and hold the or Buttons play the previous/next available radio station. Repeat

the same procedures until the desired radio station is searched and play.

5. If the reception is not good, turn the FINE TUNE Knob for better reception.

6. Turn the VOLUME Control Knob to adjust volume level as desired.

7. When finished listening, slide the Function Selector to OFF position to power off the unit.

Radio stations preset:

1. Power on the radio and receive the desired radio station as the previous procedure.

2. Press the M Button, "P XX" will appear on the LCD Display. Press the or Buttons

repeatedly to select the program number you want stored to. Then press the M Button again to

store it.

3. Repeat the same procedures until all the desired radio stations are stored into the program list.

(Up to 20 AM stations and 30 FM stations can be stored.)

4. After programming, press the or Buttons repeatedly in radio mode to select and play the

desired stored radio station.

Antennas:

AM:

This unit has a built-in ferrite rod antenna, which provides adequate reception in most areas. If

reception is weak, turn the unit to improve reception.

FM:

The FM Telescopic Antenna is for FM reception only. If reception is weak, adjust the length and the

angle of the antenna.