Owner`s manual

the number buttons or [CH +/—].
2 Press [SETUP] to display
"SETUP" menu.
3 Select "CHANNEL" using [A / T],
then press [OK].
4 Select "ANTENNA" using [A / T],
then press [OK].
CAUTION:
• If autoscan is skipped, digital channels
may not be received correctly.
1 Press [SETUP] to display
"SETUP" menu.
2 Select "CHANNEL" using [A / T],
then press [OK].
3 Select "AUTOSCAN" using [A / T],
then press
[OK].
STB starts receiving the signal for the
channel.
ADVANCED OPERATION
4 Select "AUTOSCAN" using [A / Y],
then press [OK].
3 Select "DISPLAY MODE" using
[
A
/
Y], then press
[OK].
•
STB starts
receiving available digital
channels and stores them in the channel
map.
• When the scanning is complete,
"AUTOSCAN COMPLETED" will be
indicated.
• After autoscan is complete, press [CH
+ / —] to verify whether STB is
receiving channels properly.
To cancel during
scanning: Press
[SETUP] or [OK].
NOTE:
• If canceled, some channels not yet scanned
may not be received. We recommend
completing autoscan.
• When you want to completely refresh the
channel map, delete all the channels, then
do the autoscan again. See
'Adding/Deleting Channels" on page 17
for details.
When "NO SIGNAL" appears on the
screen:
Verify the antenna connection, then scan
again. The STB tunes in channel 2-1 and
"NO SIGNAL" appears if the STB could
not receive any channels.
4 Select the desired display mode
using [A / Y], then press [OK].
5 Press [SETUP] to exit "SETUP" menu.
Page
15
of
25
TB100MW9 DTV Digital to Analog Converter (Set Top Box)
4/6/2009
mhtml:file://N:\WEBSITE\DTV Converter Box Manuals\Magnavox TB100MW9.mht