Owner`s manual

1 Press [SETUP] to display
"SETUP" menu.
2 Select "DETAIL" using [A / Y],
then press [OK].
3 Select "AUTO POWER DOWN"
using [A/Y], then press [OK].
Picture display
Edge
(Edge Color and Edge Type)
Font (Font Style, Font Size, Font
Color and Font Opacity)
Back
(Back Color and Back Opacity)
• The setting description for each item is
shown below.
[Font Style]
Closed Captioning font style can be
changed.
[Font Size]
Font size of the displayed caption can be
switched.
[Font Color]
Font color of the displayed caption can be
switched.
[Font Opacity]
Font opacity of the displayed
caption can be switched.
4 Select desired amount of time
using [A/Y], then press [OK].
•
Select "OFF" to cancel the auto power
down.
5 Press [SETUP] to exit "SETUP"
menu.
__________________________________________________
OTHERS
Before requesting service for this STB, check the table below for a possible cause of the
problem you are experiencing. Some simple checks or a minor adjustment on your part
may eliminate the problem and restore proper
operation.
Symptom
Remedy
No power
• Make sure that the AC power cord is securely plugged into
the power outlet.
•
Make sure that the POWER indicator is
lit.
The STB is not
responding to the
remote control
• Make sure to point the remote control at the remote control
sensor.
• You may be too far from STB. Try moving closer.
• Remove any obstacles between the remote control and the
remote control sensor.
• Make sure that the batteries are installed in the correct
direction (+ and -).
•
The batteries may be
depleted. Replace them with new ones.
No picture
• Make sure that the video cable is correctly connected.
• Make sure that video devices (TV or monitor) are turned on.
• Make sure that video devices (TV or monitor) are correctly
set to STB video output channel. Refer to your TV's manual
for further information.
• Check the video cable.
• Check the antenna and the RF cable. There may be damage
or interfering
sources.
Blocked noise on picture
•
There may be interfering
sources.
No EPG or the
provided information
is wrong
• Make sure that "DST" and "TIME ZONE" is set correctly in
"TIME" menu or in "SETUP
WIZARD".
No sound
• Make sure that the audio cable is correctly connected.
• Make sure that audio devices (stereo, TV or decoder) are
turned on.
• Make sure that audio devices (stereo or decoder) are
correctly set to STB audio output channel.
• When TV has only one audio input jack, use a standard audio
cable (white) to connect the audio output jack (white) on STB
to the audio input jack on the
TV.
Low volume
• Sound volume differs depending on the audio out setting.
Select "RF OUT" at step 5 in the "Setup Wizard" on page 13 if
you feel the volume is too
low.
•
Make sure to
complete autoscan in "SETUP WIZARD"
Page
20
of
25
TB100MW9 DTV Digital to Analog Converter (Set Top Box)
4/6/2009
mhtml:file://N:\WEBSITE\DTV Converter Box Manuals\Magnavox TB100MW9.mht