Owner`s manual

27EN 27EN
Recording
Playback Editing
Introduction
Connections Basic Setup Function Setup Others
Español
BASIC RECORDING & ONE-TOUCH TIMER RECORDING
7
Press [STOP C] to stop recording.
The recorded title will appear in the title list.
(Refer to “Guide to a Title List” on page 56.)
e.g.) DVD+R
Writing to Disc
Please finalize the disc when the writing is
completed before playing back on other DVD
players.
90%
1 SP(2Hr)
2
EMPTY SPACE
1:41:17
SP(2Hr)
NOV/20/11 11:00 AM L1 SP
SUN NOV/20/11 0:20:44
• Press [STOP C] to exit the title list.
6
Press [REC] to start recording.
“I” will be displayed for 4 seconds.
I
SP(2Hr) 0h58m
Press [PAUSE F] to pause recording.
Press [PAUSE F ] or [REC] again to restart
recording.
To set one-touch timer recording (OTR)...
This is a simple way to set the recording time in blocks
of 30 minutes.
Press [REC] repeatedly until the desired recording time
(30 minutes to 6 hours) appears on the TV screen.
One-touch timer recording will start.
0h30m
(normal recording)
6h00m
5h30m
1h00m
I
0h30m
To change the recording length during the one-
touch timer recording:
Press [REC] repeatedly until the desired length appear.
To cancel the one-touch timer recording within the
specified time:
Press [STOP C].
Note
• When you press [REC], recording starts immediately and continues until the disc is full or you stop recording.
• This unit cannot record images as aspect ratio of 16:9. The 16:9 images will be recorded as 4:3.
• When the unit clock has not been set, the space for a date and time of title names will be blank.
• You cannot change the recording mode during the recording pause mode.
• You can change a channel to be recorded during the recording pause mode.
Note for one-touch timer recording
• The remaining recording time will be displayed during one-touch timer recording. Press [DISPLAY] to see it on
the TV screen.
• Unlike the timer recording, you can perform the following operations during one-touch timer recording.
- Turning the power to standby to stop one-touch timer recording.
- Using [REC] or [STOP C] on the remote control.
• You cannot use the pause function during one-touch timer recording.
• When one-touch timer recording is finished and the power is turned to standby, the unit will switch to the timer-
standby mode automatically if a timer recording has been programmed. Press [STANDBY/ON
y] to cancel the
timer-standby mode to use the unit continuously.