Digital Video Disc Recorder Owner's Manual

15EN 15EN
Recording Playback Editing
Introduction
Connections
Basic Setup Function Setup Others
Español
CONNECTION
HDMI Mode and Actual Output Signals
Press [HDMI] to select the HDMI output mode. The output mode changes as follows every time [HDMI] is pressed.
On Screen Display Video Output Signal
480p 480 Progressive
Press [HDMI]
720p 720 Progressive
Press [HDMI]
1080i 1080 interlaced
Press [HDMI]
1080p 1080 Progressive
Press [HDMI]
• The HDMI mode that is not supported by display device will be skipped.
• “---” will be displayed when it dose not have any information.
*HDMI: High Definition Multimedia Interface
Copyright protection system
To play back the digital video images of a DVD via an HDMI connection, it is necessary that both the player and the display
device (or an AV amplifier) support a copyright protection system called HDCP (high-bandwidth digital content protection
system). HDCP is copy protection technology that comprises data encryption and authentication of the connected AV device.
This unit supports HDCP. Please read the operating instructions of your display device (or AV amplifier) for more information.
Note
• Some devices with an HDMI input may not operate properly with this unit.
• When using an HDCP-incompatible display device, the image will not be viewed properly.
• Among the devices that support HDMI, some devices can control other devices via the HDMI connector; this unit can be controlled
by another device via the HDMI connector.
• The audio signals from the HDMI connector (including the sampling frequency, the number of channels and bit length) may be
limited by the device that is connected.
• Among the monitors that support HDMI, some do not support audio output (for example, projectors). In connections with device
such as this unit, audio signals are not output from the HDMI output connector.
• When this unit’s HDMI connector is connected to a DVI-D compatible monitor (HDCP compatible) with an HDMI-DVI converter cable,
the signals are output in digital RGB.
• When the power failure occurs, or when you unplug the unit, some problems in the HDMI setting might occur. Please check and set
the HDMI setting again.
• HDMI outputs the video / audio signals without converting to analog signals.
• No audio connection is required.
ANTENNA
IN
OUT
rear of this unit
VHF / UHF
antenna
cable TV
company
or
ANT. IN
This connection is for
TV loop through only
RF coaxial
cable
RF coaxial cable
Do not tilt the connector when inserting it into the HDMI jack, and make sure the
shapes of the jack and the connector are matched.
VIDEO
IN
AUDIO IN
(
L1
)
S-VIDEO S-VIDEO
ANTENNA
AUDIO OUT
COMPONENT
VIDEO OUT
DIGITAL AUDIO OUTPUT
PCM/BITSTREAM
IN OUT
COAXIAL
L
R
L
R
Y
P B /C B
P R /C R
VIDEO
OUT
IN
OUT
HDMI OUT
HDMI OUT
HDMI IN
HDMI cable
Connection to a TV with an HDMI™ Compatible Port
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
Please purchase the rest of the necessary cables at your local store.
E7S50UD_ZC357MGX_v1.indd 15E7S50UD_ZC357MGX_v1.indd 15 2008/12/01 13:57:012008/12/01 13:57:01