User Manual

Pull the MMC 2 out until you feel the slight resistance of the Cam/Stop. (Note- If you do not feel the resistance of the
Cam/Stop, the Cam has been rotated 180 degrees and the Cam must be rotated further until the Cam and Stop
intersect.) Insert the long 5/64 inch allen wrench into the Cam/Stop at the bottom of the speaker as shown in Fig. 1
and 2 below and loosen the allen screw. Rotate the MMC 2 to the desired position as shown in Fig. 3 and 4 while
holding the Cam/Stop stationary. It is necessary to raise the MMC 2 slightly to remove the weight of the speaker off
of the Cam/Stop so that the speaker can be rotated independently of the Cam/Stop.Tighten the allen screw. If the
Cam/Stop moves in the process of moving the MMC 2, the angle will be wrong. In that case, another adjustment
will be necessary.
Lift the speaker panel as high as possible to expose the allen screws. Insert the long 5/64 inch allen wrench into
the allen screws in the Cam/Stop at the bottom of the speaker as shown in Fig. 1 and 2. Loosen all but one of the
allen screws (Your cam may have 2 or 3 allen screws). Next, pull the MMC 2 out until you feel the slight resistance
of the Cam/Stop. (Note- If you do not feel the resistance of the Cam/Stop, the Cam has been rotated 180 degrees
and the Cam must be rotated further until the Cam and Stop intersect.) Maintain the speaker panel at the position
where the Stop has hit the Cam. Lift the speaker panel as high as possible to gain access to the allen screws.
Insert the long 5/64 inch allen wrench into one tightened allen scew in the Cam/Stop. Loosen the allen screw and
use the allen wrench to hold the cam at the same position while you rotate the MMC 2 to the desired position. It is
necessary to keep the weight of the speaker panel off of the Cam/Stop so that the speaker can be rotated
independently of the Cam/Stop. Tighten the allen screw. Invariably, the Cam/Stop will move slightly in the process
of moving the speaker panel and the angle will be wrong. In that case, another adjustment will be necessary. The
last step is to check the panel angle by using the Controller/Power Supply which may not be the exactly the same
as the manual setting.
The angle of the MMC 2 should never be set for less than 30 degrees for optimum sound.