User guide

1. INTRODUCTION
Congratulations on your purchase. The Magneplanar MMG W loudspeaker was conceived and
designed for perfectionists. One of the most revealing loudspeakers made, it will provide outstanding
music and home theater reproduction when used with high quality components. Due to the elegant
simplicity and ruggedness of the design, the Magneplanar MMG W loudspeaker will give many years
of trouble-free service.
2. PACKAGING
Save all packaging. If you need to transport the speakers, they can be shipped safely only in the
original packaging. You may never have to ship your loudspeakers, but should the occasion arise,
they should not be shipped in any packaging but the original. Should you discard it, you may purchase
new packaging from the factory.
3. INSTALLATION
The MMG W is a multi-channel speaker designed for front channel, side, or rear channel applications.
The MMG W has a frequency response from 100Hz to 16kHz and is intended for use with a
subwoofer. Set your processor or receiver to "small speaker" for the MMG W. Frequencies below
100Hz will be assigned to the subwoofer. The MMG W is designed to be placed next to a wall or
cabinet. The boundary of a wall or cabinet is calculated in the MMG W design to achieve smooth
frequency response to 100Hz.
In front and surround applications, the front of the diaphragm should be faced toward the
listener. The back of the diaphragm contains a wood crosspiece, the front does not.
Melted diaphragms are not covered under the speaker warranty.
Connect the (+) (red) output from your amplifier to the white wire (with red mark) on the MMG W, and
(-) (black) of the amplifier to the all white wire on the MMG W. If the speaker wires are not routed
through a wall or cabinet, "hide-a-cord" channels can be attached to the wall as shown below.