Instruction Manual

QUICK SET-UP
1. Remove panels and feet from the carton. KEEP ALL PACKAGING! If you should ever return the speakers to
Magnepan, they must be returned in their original carton. There will be a charge if it is necessary to replace
packaging.
2. Install the feet on the back of the speakers and tighten the screws. If the little flippers on the ends of the feet do not
fall loosely by their own weight, spread their ends apart until the friction is eliminated.
3. The MMG uses a unique high-current connector (See Figure 1). Strip approximately 1/4-inch of insulation from the
speaker cable end and insert it into the connector and tighten the set screw with the Allen wrench provided. Special
spade lug adapters are available from Magnepan...call to order.
Magnepan encourages the use of large gauge speaker wire(preferably 16 gauge or larger).
TO INSURE PROPER PHASING OF THE SPEAKERS, MAKE SURE PLUS (+)IS TO PLUS AND MINUS (-) IS TO
MINUS.
4. Your speakers come in matched pairs and are mirror-imaged. The serial number for each speaker in the pair is the
same except a "1" or "2" follows each serial number. Place speaker "1" on the right and "2" on the left. This places
the tweeters nearest the inner edges of the speakers.
5. Locate the speakers 2 feet or more in front of a wall.
6. The distance between the speakers should be approximately 60% of the distance you will be from the speakers
when you listen to them, for example: if you will be10 feet from the speakers, position them about 6 feet apart.
7. Aim your speakers at your listening position.
8. ENJOY!