Owners Manual

© 2015 Sensata Technologies 3
Introduction
1.6 Features – CMW1012 and CMW1512
The front panels of the CMW1012 and CMW1512 inverters are similar and
are equipped with the following features (see Figure 1-3):
1. Serial Number – the unique identifi cation number assigned to each unit
(with a model-specifi c prefi x). Note: Enter your inverter’s serial number in
the table at the bottom of page i. It is to easier to record this information
now, instead of trying to gather it after the unit has been installed.
2. GFCI – a Ground Fault Circuit Interrupter protected AC outlet. The GFCI
outlet quickly stops the fl ow of electricity in the event a ground fault
occurs on the device that is plugged into the inverter.
3. Status Indicator – an at-a-glance LED that provides the inverter’s
status—lights green, red, or amber (see Section 3.0 Operation).
4. Digital Display – a three-character alphanumeric display that shows
the inverter’s measured battery voltage, total AC output power, and any
error or warning codes.
5. Power/Select Button – a momentary button switch that allows the
inverter to be quickly turned on or off.
6. Remote Port – a RJ11 connector that allows an optional remote switch to
be connected via a remote cable. Note: Remote switch is sold separately.
7. USB Port – allows USB-enabled devices to be powered and charged.
Figure 1-3, Front Panel Features (CMW1012 and CMW1512)
2
1
CMW1512 Power Inverter
Serial Number
120VAC 60Hz, 1500W/12.5A continuous
Modified Sinewave Output
USB
Remote
Status
Power/Select
BM-00001
3
4
5
6
7
Input: 12.5 VDC,
38A
CMW412
Warning:
Do not operate
or install on or
above
combustible
surfaces.
Reverse
polarity will
damage unit.
7 8
9
10
Figure 1-2, Back Panel Features (CMW412)