Owner`s manual

© 2010 Magnum Energy, Inc.Page 10
3.0 Installation
3.0 Installation
Info: Installations should be performed by qualifi ed personnel, such as a licensed
or certifi ed electrician. It is the installer’s responsibility to determine which safety
codes apply and to ensure that all applicable installation requirements are followed.
Applicable installation codes vary depending on the specifi c location and application of
the installation.
CAUTION: Review the “Important Product Safety Information” on page 1 and the
“Important Battery Safety Instructions” on page 2 before any installation.
CAUTION: The MMP enclosure is heavy. Use proper lifting techniques during installation
to prevent personal injury.
The simplifi ed system diagram shown in Figure 3-1 should be reviewed to assist you in planning
and designing your installation. This drawing is not intended to override or restrict any national
or local electrical codes; and should not be the determining factor as to whether the installation
is compliant, that is the responsibility of the electrician and the onsite inspector.
3.1 Preparation
Before installing the inverter, read the entire installation section to determine how you are going
to install your MMP enclosure. The more thorough you plan in the beginning, the better your
inverter needs will be met.
3.1.1 Unpacking and Inspection
Carefully remove the MMP enclosure from its shipping container and inspect all contents. Verify
the following items are included:
MMP enclosure• RJ14 Extension Cable• 3/8-16 x 1” Bolt•
Inverter Hood• 6’ Network Cable• 3/8” Split Lock Washer•
Owner’s Manual• 6’ Remote Cable•
Four 8-32 x 1/2 Phillips drive, black colored screws taped to the back of the blank plate.•
If items appear to be missing or damaged, contact your authorized Magnum Energy dealer or
Magnum Energy.
Save your proof-of-purchase as a record of your ownership; it will also be needed if the unit should
require in-warranty service.
3.1.2 Required Materials and Tools
The following material and tools may be required for installing this equipment:
Materials
Conduit, strain-reliefs, and appropriate fi ttings• 1/4” mounting bolts and lock washers•
Electrical tape• Wire ties•
Conductors/cables for wiring•
Tools
Miscellaneous screwdrivers• Insulated pliers• Wire cutters/strippers•
Drill and drill bits• Pencil or marker• Multimeter•
Level• 1/2” wrench•
Torque wrenches• Ratchet drives•