Owner`s manual

Appendix A - Optional Equipment and Accessories

Figure A-1, Installing a Remote Control on the MMP Enclosure

Appendix A - Optional Equipment and Accessories

A-1 Installing a Remote Control

Complete the steps below to install the ME-RC or ME-ARC remote control on the MMP enclosure;

refer to Figure A-1 for assistance.

1. Unscrew the blank plate from the front cover, and remove the four 8-32 x 1/2 Phillips drive,

black colored screws taped to the back of this blank plate.

Info: The blank plate is attached to the front cover using #8-32 Hex nuts. Use a 11/32”

socket or wrench to remove/reattach these nuts.

2. Use these four screws and the four nuts that were used to hold the blank plate to attach the

remote control to the front cover.

3. Run the yellow colored remote cable that is provided between the remote and the Magnum

inverter/charger.

Info: The remote cable is a 4-wire, twisted-pair, telephony standard with 300-volt rated

insulation, and uses RJ14 (m) connectors on each end (see Figure 3-24). A standard

telephone cable would not be code-compliant and should not be used.

4. Connect one end of the remote cable into the RJ14 “REMOTE” port (has blue label) on the in-

verter/charger, and the other end into the RJ14 jack on the back-side of the remote.

BLANK

LATE

FRONT COVER

(REAR VIEW)

FRONT COVER

(FRONT VIEW)