Owner`s manual

Page 53
© 2010 Magnum Energy, Inc.
Appendix A - Optional Equipment and Accessories
Figure A-2b, Wiring the Sense Module and DC Shunt
Figure A-2a, Mounting the Sense Module
A-2 Installing a Battery Monitor
DC Fuse (2 amps)
To DC
Positive Busbar
To DC
Negative Busbar
orange
blue
black
red
black
red
Twisted-pair cable
4-Port Terminal Block
(can be removed, and
each port accepts
30 to 12 AWG wire).
Communications Cable
(To Network Port on
Magnum inverter)
blue
orange
To Battery Bank
To Inverter/Loads
Close-up of wiring
the M E -B M K
Sense Module
(from ME-BMK)
DC Shunt
(in MMP Enclosure)
DC Positive Busbar
(in MMP Enclosure)
DC Negative Busbar
(in MMP Enclosure)
To Network Port
MOUNTING DIMPLES WITH
#8 SCREW HOLES (X2)
SENSE MODULE
(PART OF ME-BMK-NS)
TWO #8 X 1/2”,
T15 TORX DRIVE SCREWS
(PROVIDED AND SCREWED INTO
THE
TWO MOUNTING DIMPLES)