Owner`s manual

2.0 Introduction

2.1 MMP Series Overview

The MMP enclosures are available in four basic conﬁ gurations; this section lists the four models

and the main components and features.

Individual Models:

MMP175-30D (Mini Magnum Panel, 175 ADC breaker, dual 30 AAC bypass/input breakers)

MMP175-60S (Mini Magnum Panel, 175 ADC breaker, single 60 AAC bypass/input breakers)

MMP250-30D (Mini Magnum Panel, 250 ADC breaker, dual 30 AAC bypass/input breakers)

MMP250-60S (Mini Magnum Panel, 250 ADC breaker, single 60 AAC bypass/input breakers)

Standard Features:

Enclosure is steel construction with durable white powder coat ﬁ nish

Battery/inverter DC disconnect breaker (175 or 250 amp)

Inverter AC input overcurrent protection breakers

Pre-wired AC bypass switch for inverter isolation/battery maintenance

Front mount AC and DC breakers for quick and easy operation

AC and DC Ground screw type compression terminals (no lugs required)

500A/50mV DC shunt installed for easy connection to Battery Status monitor

Easy ﬁ eld wiring with front mounted AC and DC input/output terminals

Enclosure and components are UL/CSA certiﬁ ed and designated for indoor use

Conﬁ gurations available for both single 120VAC and 120/240VAC systems

DC negative and ground busbars (negative can be isolated if PV-GFP device installed)

Battery positive busbar for DC loads and PV arrays included

Provides mounting for DIN rail or back-mounted DC load/disconnect breakers

Integrates directly with Magnum ME, MS, MS-PAE, and RD Series inverters

Top cover plate provided to allow other (non-Magnum) inverter installations

Knockouts for inverter and battery cables, PV in/out, DC breakers

Stud terminal available for large DC wire if used as system ground

Data cables with 300 volt rated insulation provided to allow 240 VAC inverter installations

Inverter hood provided to allow a Magnum inverter to be mounted vertically

Physical Features:

MMP Dimensions (H x W x D): 18” x 13” x 6.75” (45.7cm x 33cm x 17.1cm)

MMP Weight: 22.5 lbs. (10.2 kg)

Shipping Dimensions (H x W x D): 22” x 15” x 12.5” (56.9cm x 38.1cm x 31.8cm)

Shipping Weight: 31.5 lbs. (14.3 kg)

Optional Accessories/Components:

ME-RC – Remote Control with LCD display; allows inverter (or connected accessory) to be

conﬁ gured and monitored, and maintain the critical settings in nonvolatile memory.

ME-ARC – Advanced Remote Control with LCD display; has all the features of the ME-RC remote,

but also conﬁ gures the advanced features of the inverter (or any connected accessory).

ME-BMK-NS – Battery monitor; determines Battery State of Charge (DC shunt not included).

ME-AGS-N – Automatic Generator Start Controller (network version); automatically starts/

stops generators.

BP-MMP – Metal Backplate; for mounting the Magnum inverter and MMP enclosure, and is UPS

shippable. See Figure A-3 in Appendix A for more speciﬁ c information.

DC Breakers – Space for up to four E-Frame/back mounted (1” width) or eight Q-Frame/DIN

rail mounted (1/2” width) DC breakers.

•