Installation Manual

Page 78
© 2014 Magnum Energy, Inc.
Using an AGS Module: Operation/Monitoring
Figure 7-2, AGS CTRL/METER Menu Map (Section 1)
METER
[Status/Fault]
04 AGS Meters
04A AGS Status
[AGS Status]
04B DC Volts-AGS
14.4 VDC
04C Gen Run Time
02.2 Hrs
04D AGS Temp
77F
04E Since GenRun
13 Days
Read Only displays
CTRL
03 Gen Control
OFF
Set Gen Control
OFF
Set Gen Control
ON
Set Gen Control
AUTO
AC In Start Amp Fault Amp Fault Test
Gen Cooldown Start Exercise Fault Exercise Fault Time
Gen Warm-up Start SOC Fault Gen Run Fault Topoff
Manual Run Start Temp Fault MaxRn Fault VDC
No Comm Start Test Fault SOC Fault 100% SOC
(No AGS present) Start Time Fault Temp
Off Start Topoff
Quiet Time Start VDC
Ready Start 100% SOC
Available Statuses:
P
R
R
P
R
R
R
R
04G Hour Meter
00013 Hrs
04F Since 100%
13 Days
R
R
Press and hold the SELECT
button for 3 secs to reset
P
LEGEND
Menu Selections
Menu Button
Default/Current
Setting
Change Settings
Menu Heading
Press SELECT
SETUP
Press button
Set Gen Exercise
Days = OFF
04H Gen Exercise
OFF
** For this menu map, the arrow denotes the factory default settings
P
R
= rotate SELECT knob
… = all screens not included
7.2.5 AGS Menu Maps
This section provides the AGS menu maps available from the CTRL, METER, SETUP and TECH but-
tons on your ME-ARC remote.
Note: When applicable, battery voltage defaults and ranges are shown for a 12-volt battery (24-
volt systems multiply by 2; 48-volt systems multiply by 4).