Installation Manual
Table Of Contents
- 1.0 Introduction
- 2.0 Installation
- 2.1 Preparation
- 2.2 Location
- 2.3 Conduit Knockouts
- 2.4 Mounting
- 2.5 Wiring the MMP Enclosure – General Requirements
- 2.6 Torque Requirements
- 2.7 Electrical System Wiring Diagrams
- 2.8 DC Wiring
- 2.9 AC Wiring
- 2.10 MMP/Inverter System Grounding
- 2.11 Removing the AC Neutral to Ground Connection
- 2.12 Removing the DC Negative to Ground Busbar
- 2.13 Wiring Accessories
- 2.14 Installation Checklist
- 2.15 Functional Test
- 3.0 Operation
- Appendix A – Optional Equipment and Accessories
- Appendix B – Using the MMP in a Mobile Application
- Appendix C – Warranty and Service
Page 39
© 2013 Magnum Energy, Inc.
Installation
Figure 2-25, Accessory Wiring using 300 Volt Communications Cables
REMOTE Communication
Cable (300-volt rated)
REMOTE
REMOTE
.
N
E
T
W
O
R
K
NETWORK
NETWORK Communication
Cable (300-volt rated)
Extension Cable (300-volt rated)
ME-AGS-N
ME-RC or
ME-ARC
Front cover of MMP
enclosure (back side)
ME-BTS
.BTS