Lithium Battery Settings Quick Reference Guide

LED Indicators
On/Off Push Buttons
Menu Buttons
Rotary Select Knob
LCD Display
Lithium Battery Settings
QUICK REFERENCE GUIDE
STANDARD LFP SETTINGS AVAILABLE FOR THE FOLLOWING MAGNUM ENERGY INVERTER/CHARGER MODELS
Using the Magnum Energy ME-RC or ME-MR Remote Controls, set Magnum Energy
inverter/chargers to charge lithium iron phosphate (LFP) batteries.
• MS2000
• MS2012
• MS2812
• MS2024
• MS4024
• MS4048
• MSH3012M
• MSH3012RV
Access LFP battery settings
via built-in RV control panels
using the ME-RVC bridge.
ME-RC Remote Control
From the ME-RC Remote Control version 2.9 or higher,
program your Magnum Energy inverter/charger to
charge lithium batteries.
STEP TWO: Set the Absorb Time setting
to battery manufacturer’s specifications.
The setting is determined by the 20-hour
amp-hour capacity of your battery bank.
Press Setup
Rotate to Absorb Time
Press Rotary Knob
to select
Rotate to 1 hour
Press Rotary Knob to save
Status...
03 Absorb Time
Status...
Absorb Hrs = 1.0
STEP THREE: Set the Battery Type
setting to LFP.
Status...
04 Battery Type
Status...
BatType = LFP
Press Setup
Rotate to Battery Type
Press Rotary Knob
to select
Rotate to LFP
Press Rotary Knob to save
• MSH4024M
• MMS1012
• MMSA1012
STEP ONE: Set the Low Battery Cutout to
battery manufacturer’s specifications.
Press Setup
Rotate to Low
Battery Cutout
Press Rotary Knob
to select
Rotate to battery
manufacturer’s specs, or
11.0 VDC if not specified.
Press Rotary Knob to save
Status...
02 LowBattCutOut
Status...
LowBattCutOut = 11.0