Instruction manual

15
• Always track belts prior to running material, belts may need to be adjusted once material starts
running. See page 37 for belt tracking instructions.
• Minimize side load/feed of belt in hopper area to minimize tracking issues.
• Make sure material is being fed on the center of the belt as much as possible.
• Check all conveyor flashing to make sure it is in the proper position and fully tightened to
reduce spillage.
• Check “V-Belts” on belt drive for proper tensioning. See page 44 for “V-belt” tensioning
instructions.
• Check “Belt Cleaner” for proper tensioning.