Operator`s manual

PRE - START CHECK LIST

Before starting the generator, carefully read the pre-start check list. Make sure that all of the items are checked before

trying to start the generator. This check list applies to both manual and remote starting of the generator.

 Read and understand ALL safety sections at the beginning of this manual.

 Make sure the control ON/OFF toggle switch is in the OFF “O” position.

 Make sure that the circuit breakers (main and convenience) are switched OFF “O”.

 Check that the generator is properly grounded to a good earthen ground per any local and NEC

regulations.

 Check all electrical connections at the connection lugs. Are they wired correctly?

 Are the connection lugs tight?

 Check the voltage selector switch and make sure that it is set to the desired voltage.

 Is the voltage selector switch locked?

 Is the generator sitting level?

 Thoroughly check for any water inside the unit, on or near the generator. Dry the unit before starting.

 Check oil, coolant and fuel levels and engine battery connections.

 Check engine fan belt tension and condition.

 Check engine fan belt guard.

 Check engine exhaust system for loose or rusted components.

 Check radiator and surrounding shroud for debris.

 Are any of the generator covers loose or missing?

 Are all preventative maintenance procedures up to date?

 Check that the battery disconnect switch is on, if equipped.

MANUAL STARTING OF THE GENERATOR

1. Move the control ON/OFF toggle switch to the “CONTROL ON / I” position.

DANGER

CARBON MONOXIDE: USING A GENERATOR INDOORS CAN KILL YOU IN MINUTES!

2. The Liquid Crystal Display (LCD) window will quickly display system information, all Light Emitting Diodes (LED’s)

will flash.

3. The LCD window will indicate “MAN” (manual) mode and “Ready”. The Ready/Manual LED will be lit.

Note: The unit must be in the “MAN” Mode with the Ready/Manual LED lit to start the unit.