Owner's Manual
Installation & Adjustment
05
Step 5. Install the Front Wheel
wheel in to the fork.
the bike box. Move the front wheel between the front fork until the fork dropout (notches) are in place on
washer on the axle should sit outside the fork dropout.
Put the quick release skewer through the axle and tighten the nut until the quick release lever begins having
resistance at the halfway closed point. Once the front wheel is securely installed, prop the kickstand down
to hold up the bike.
Step 4. Install the Front Fender & Headlight
Slide the fender through the front fork above the tire. Use a 4mm hex key on the bolt and 10mm box wrench
on the nut to tighten the attachment points to the silver fender holder.
Find the front light that comes separate in the bike box. It should be attached to a cord. Use a 5mm hex key
and 15mm box wrench to tighten the front light attachment points and then connect the cord.