Owner`s manual

20
DC CONTROL PANEL/THERMOSTAT HOOK-UP
WARNING: ALWAYS DISCONNECT POWER CORD DURING ANY ELECTRICAL
OPERATION
0. Remove control panel from protective packaging.
inside
ove.
NO U
thermosta
OTE: If you are not going to use the thermostat function then skip steps #4 - #8 and go to Step #9.
ute the wires into the stove near where the AC power cord enters.
o the lower position. (see details
of the control panel.
lowing the stove to operate at the medium or higher settings. When the room
g the stove
17. illips
Not e t
Fuel Feed C
1
11. Connect the one way molex plug to the control panel; do not pull on the wire harness
the st
TE: se only a low voltage mercury or bi-metal thermostat switch. (No power required on
t)
N
12. Locate the thermostat on a wall six (6’) to (10’) feet away.
13. Ro
14. Pull the thermostat wire through to the control panel cut-out.
15. Move the factory installed jumper from the upper position t
below)
16. Connect the thermostat wires to the two terminals on the back
When the room temperature drops below the thermostat setting, the thermostat switch will
close, al
temperature matches the thermostat setting, the thermostat switch will open, allowin
to operate at the low setting.
Locate the control panel into the side panel cut-out and secure with four (4) #7 X ½ Ph
screws (supplied). Do not over tighten. Set to Thermostat operation on the top front of the
board.
18. The stove is now ready for operation. Refer to the OPERATING INSTRUCTIONS.
e: Th hermostat function of the stove will cycle with the room temperature when the
ontrol” is set at a medium or higher setting.
“
The Thermostat wire connection is located on the back of the board
just above the white molex connector.
To operate t
switch in th
he unit in the thermostatic operation mode, place the selector
e T-Stat position. (Center position)