Owner`s manual

36
to one of the medium or higher settings. The unit will
dium to high). When the room
unit to operate a or higher settings. Wh mpe he
ermostat setting, the thermo pen, allowin the stove to operate at the low
setting.
OSTAT EQUIPMENT REQUIRED (is optional): A low voltage millivolt
tha tica setti usly selected.
the 20 A uctors.
UM P WITC E PRESSURE SENSOR:
A blocked flue, a down draft, open door, open hopper lid, negative or positive pressure in the
rafty locatio of the applianc not hooking up the outside air, im g or
maintenance of the 3” inch exhaust venting from the stove will cause the pressure switch to
ut off the auger. o resume operation, it is necessary to locate the cause and correct it.
t the unit following the ins anual.
TEMP THERMODISK/S
unit overheat it will shu safely s
cooled and the reset button is depressed. (See Thermodisk location section) If the auger does
not turn after cleaning the back of the unit, you might have tripped this disk. To reset high
enter button until it clicks into place.
er
s wet,
to
he
G.
osition, the blowers will continue to run
nd
e
s
AUTOMATIC FEATURES
A. THERMOSTAT OPTION (Optional):
When using a thermostat, set the unit
burn at the rate selected on demand by the thermostat (me
temperature drops below the thermostat setting, the thermostat switch will close, allowing the
en the room tet the medium rature matches t
th stat switch will o g
B. THERM
thermostat
Type CL2
t will automa
rmostat wire-
lly switch between
WG, 2 cond
ngs previo
C. VACU RESSURE S H/STOV
home, d n e, proper ventin
sh
Restar
T
tructions in this m
D. HIGH
If the
NAP DISK:
t itself downs, . The unit may not be restarted until it ha
temp push in on the c
E. SELF-IGNITER (Optional):
Automatically ignites the pellets within 3-5 minutes, without the use of fire starter. The ignit
will continue to run for approximately 10 minutes until a fire is established. If the fuel i
poor quality or the hopper has not been primed, it might take 2 or 3 cycles for the unit
properly light. Using a small amount of fire starter will help with this.
F. PROOF OF FIRE THERMODISK/SWITCH/SNAP DISK:
If the temperature required by the PROOF OF FIRE thermodisk is not high enough within t
10 (15 minutes on the AC models) minute cycle, the auger will stop feeding fuel.
COOL DOWN SENSOR/SWITCH/LOW LIMIT: (Same as Proof of Fire Thermodisk)
After the power switch has been moved to the “OFF” p
for approximately 45 minutes. The cool down sensor will allow the stove to cool down a
then automatically shut itself off. If the hopper runs out of fuel and the stove cools off, th
auger will stop feeding. However, the blowers will continue to run until the POF switch ha
cooled down to initiate the shut down cycle