00-MILLIMETER SWIPE READER WITH SHIFT-OUT ASIC TECHNICAL REFERENCE MANUAL Part Number 99875287-3 MAY 2004 REGISTERED TO ISO 9001:2000 1710 Apollo Court Seal Beach, CA 90740 Phone: (562) 546-6400 FAX: (562) 546-6301 Technical Support: (651) 415-6800 www.magtek.
Copyright© 2003-2005 MagTek®, Inc. Printed in the United States of America Information in this document is subject to change without notice. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of MagTek, Inc. MagTek is a registered trademark of MagTek, Inc.
LIMITED WARRANTY MagTek warrants that the products sold to Reseller pursuant to this Agreement will perform in accordance with MagTek’s published specifications. This warranty shall be provided only for a period of one year from the date of the shipment of the product from MagTek (the “Warranty Period”). This warranty shall apply only to the original purchaser unless the buyer is authorized by MagTek to resell the products, in which event, this warranty shall apply only to the first repurchase.
FCC WARNING STATEMENT This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
TABLE OF CONTENTS SECTION 1. FEATURES AND SPECIFICATIONS..................................................................................... 1 CONFIGURATIONS ................................................................................................................................. 1 SPECIFICATIONS .................................................................................................................................... 2 REFERENCE DOCUMENT ....................................................
Figure 1-1.
SECTION 1. FEATURES AND SPECIFICATIONS The 100-millimeter Magstripe Swipe Reader with Shift-Out ASIC is designed for providing magstripe read capabilities for use in the retail, access control, and time and attendance environments. The reader chassis provides an industry standard mechanical footprint, along with magstripe read capabilities, which comply with the ISO 7810/7811 and AAMVA standards.
100mm Swipe Reader With Shift-Out ASIC SPECIFICATIONS Flammability Speed STANDARDS Meets UL94V-0 Card speed through the unit may vary from: 3 to 60 in/s (7.6 to 152.
SECTION 2. INSTALLATION This section consists of installation and connection of the Reader. MOUNTING The dimensions for mounting are shown below. CONNECTORS The connector pin lists are shown below. Connector J2 is provided for easy access without removing the PC board. If additional strain relief is required, J3 may be used, and a tie wrap can be routed through the holes adjacent to J3 to secure the cable. The mating connector is Housing Molex PN# 51021-0400 Terminal Molex PN# 50058-8000, 4 required.
0mm Swipe Reader With Shift-Out ASIC 4
APPENDIX A.
100mm Swipe Reader With Shift-Out ASIC Figure A-1.
Appendix A. Engineering Drawings Figure A-2.
100mm Swipe Reader With Shift-Out ASIC 8