43-MILLIMETER COMPATIBLE SWIPE READER TECHNICAL REFERENCE MANUAL Part Number 99875146-4 JULY 2008 REGISTERED TO ISO 9001:2000 1710 Apollo Court Seal Beach, CA 90740 Phone: (562) 546-6400 FAX: (562) 546-6301 Technical Support: (651) 415-6800 www.magtek.
Copyright© 1999-2008 MagTek®, Inc. Printed in the United States of America Information in this document is subject to change without notice. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of MagTek, Inc. MagTek is a registered trademark of MagTek, Inc.
LIMITED WARRANTY MagTek warrants that the products sold to Reseller pursuant to this Agreement will perform in accordance with MagTek’s published specifications. This warranty shall be provided only for a period of one year from the date of the shipment of the product from MagTek (the “Warranty Period”). This warranty shall apply only to the original purchaser unless the buyer is authorized by MagTek to resell the products, in which event, this warranty shall apply only to the first repurchase.
FCC Warning Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
TABLE OF CONTENTS SECTION 1. FEATURES AND SPECIFICATIONS..................................................................................... 1 CONFIGURATIONS ................................................................................................................................. 1 SPECIFICATIONS .................................................................................................................................... 1 REFERENCE DOCUMENT ....................................................
Figure 1-1.
SECTION 1. FEATURES AND SPECIFICATIONS The 43-millimeter OEM Swipe Reader has a TTL level interface and is designed for use in retail, access control, and time and attendance environments. This Reader is in compliance with industry specifications, including ANSI/ISO Standards 7810, 7811-1 through -6, 7812, and 7813 The Reader can be customized. Bidirectional read capability is available.
43-Millimeter Compatible Swipe Reader 2
SECTION 2. INSTALLATION This section consists of installation and checkout of the Reader. MOUNTING The dimensions for mounting are shown in Figure 2-1. Figure 2-1.
43-Millimeter Compatible Swipe Reader CONNECTORS Single Track I/O Connector is shown in Table 2-1, and the Dual Track I/O Connector is shown in Table 2-2. Table 2-1. I/O Connector for Single Track, 8 Pin Pin Number 1 Color Brown JAE IL-Y-8S-S15C3 2 Gray STROBE 1.5mm Contact Spacing 3 White DATA 4 Blue CARD PRESENT 5 NC 6 NC 7 NC 8 Red Connector for Single Track, 8 Pin Signal GND VCC Note: VCC = 2.4 to 5.5 VDC Table 2-2.
Section 2. Installation TIMING CARD PRESENT DATA 0 0 0 0 1 1 1 0 0 0 0 0 1 1 0 STROBE Bit Time STROBE WIDTH APPROXIMATELY 25-50% OF BIT TIME Notes: 1. Time out of the CARD PRESENT signal occurs approximately 150 ms after the last strobe transition. 2. DATA is valid 1.0μ sec before the negative edge of STROBE. Figure 2-2. Timing DATA The Data signal is valid while the strobe is low. If the Data signal is high, the bit is a zero. If the Data signal is low, the bit is a one.
43-Millimeter Compatible Swipe Reader 6
APPENDIX A. DRAWINGS The drawing shown in this section show the mounting dimensions of the 43mm Reader.
43-Millimeter Compatible Swipe Reader Figure A-1.
