Owner manual
Table Of Contents
- REGISTERED TO ISO 9001:2000
- SECTION 1. OVERVIEW
- SECTION 2. SYSTEM REQUIREMENTS
- SECTION 3. INSTALLATION
- INSTALLING THE MCP DRIVER
- CHANGING THE MCP DRIVER:
- REMOVING THE MCP DRIVERS
- DEVICE INSTANCE MANAGEMENT
- Device Instance Overview
- MCPCFG Utility Overview
- MCPCFG Command Summary
- Adding a Device Instance from Command Line – RS-232
- Adding a Device Instance from Command Line – USB
- Adding a Device Instance from Windows Based Application (WINDOWS 2000, XP) – RS-232
- Adding a Device Instance from Windows Based Application (WINDOWS 2000, XP) – USB
- Modifying a Device Instance Properties from Windows Based Application (WINDOWS 2000, XP) – RS-232 and USB
- Removing a Device Instance from Windows Based Application (WINDOWS 2000, XP) – RS232
- Removing a Device Instance from Windows Based Application (WINDOWS 2000, XP) – USB
- Removing a Device Instance from a Command Line – RS-232
- Removing a Device Instance from a Command Line – USB
- Displaying the List of Device Instances from Command Line
- Displaying Device Instance Properties from Command Line
- Modifying Device Instance Properties from Command Line
- Modifying Device Instance Properties From Windows Based Application
- Restarting the MCP Driver
- Stopping the MCP Driver From Command Line
- Windows Configuration Utility
- DEVICE INSTANCE PROPERTIES
- SECTION 4. TRACE LOG
- SECTION 5. APPLICATION PROGRAMMABLE INTERFACE
- TYPICAL OPERATION
- DEVICE CHANNEL LIFE CYCLE
- PROPERTIES
- COMMANDS
- NOTIFICATIONS
- FUNCTIONS
- Summary
- MCPBUS Structure
- Members
- Remarks
- The MCPBUS is used as an input parameter to many of the MCP API functions. The MCP driver modifies only those members explicitedly defined by the individual functions. For example, the API will not modify the lpOutBuffer or dwOutBufferSize members (the buffer that lpOutBuffer points to will of course be modified); therefore, the caller may set these values once and not need to reset them prior to invoking subsequent MCP API functions. The only structure members modified by an MCP API function are those explicitly identified as output parameters.
- McpEnum
- McpOpen
- McpClose
- McpReset
- McpGet
- McpCall
- McpWait
- CONSTANT DEFINITIONS
- FUNCTION PROTOTYPES
- INDEX
MagTek Communications Protocol, Driver Reference Manual
16
Make sure “Yes, I want to restart...” is selected and then click “Finish” to reboot and complete
the installation. The Kernel Mode driver will not load until the computer reboots. The User
Mode driver is available without rebooting, but it is recommended that you reboot at this time if
you are changing from Kernel Mode to User Mode.