User`s manual

112
Magtrol Model DSP6001 Dynamometer ControllerIndex
GPIB 65
Integral 40,42
L
LabVIEW Programming Examples 83
Line Voltage 15
M
Maximum Speed Alarm 53
Maximum Torque Alarm 54
MaxPower Setup Menu 92
Max Speed Menu 90
Memory 108
Menus 88
Alarm Setup 100
Aux Setup 21,90
Com Setup 91
Dynamometer Configuration 18,93
Dyno Setup 18,92
Encoder Setup 36,99
Hysteresis Setup 19
Main Menu 16
MaxPower Setup 92
Max Speed 90
Power Units 89
Torque Transducer Setup 21,94
Torque Units 89
Miscellaneous
Commands 75
Configuration 106
O
Open Loop Control 64
Outputs 12
Accessory Torque-Speed 12,37,80
CTRL OUT 12
Dynamometer Analog I/O 109
P
PC Configuration 101
PC Connection 67
PC Control 101
PID Loop 40,41
PID Settings 40,43
Ramp Down 48
Speed Control 46
Torque Control 43
Powder Dynamometer 41
Setup 24,26,27,28,29,31,33,97,98
Power Alarm 52
Power Bypass Capacitors 107
Power Cord 14
Power Units 62,89
Pre-Test Configuration 102
Programming 68
Proportional Gain 40,42
R
Ramp
Commands 71
Configuration 103
Ramp Down
PID Settings 48
Rear Panel 12
Remote Configuration 101
Remote Control 101
RS-232 Interface 14,66
S
Saving Function 9
Scale Factor 41
Speed DAC 37
Torque DAC 37
Schematics 107
Screen Saver 11
Secondary Functions 8
Self-Test 16
Setup
Auxiliary Instrumentation 22,28,95
Eddy-Current Dynamometer 24,26,27,28,29,31,33,95,96
,98
Hysteresis Dynamometer 19,20,22,24,27,94
Independent 29
Powder Dynamometer 24,26,27,28,29,31,33,95,97,98
Speed Encoder 36,99
Tandem 31,33,96,97,98
Torque/Speed DAC 37
Torque Transducer 20,35,94
Setup Commands 72
Simple Read 83
Speed
Commands 74
Configuration 104
Speed Check 80
Speed Control 63
PID Settings 46
Speed Correction 41
Speed DAC Scale Factor 37
Speed Encoder
Setup 36,99
Speed Stabilized 85
Status Display Messages 11
Supply 1 Connector 13,79
Supply 2 Connector 14,79
T
Tandem Setup 31,33,96,97,98
Temperature Alarm 59