User`s manual

1
GENERAL
INFORMATION
Calibration Certificate
1. Introduction
1.2 NEW FEATURES OF THE DSP6001
Magtrol’s new Model DSP6001 Dynamometer Controller is an upgraded version of the DSP6000,
providing superior motor testing capabilities by using state-of-the-art digital signal processing
technology. Designed for use with any Magtrol Hysteresis, Eddy-Current or Powder Brake
Dynamometer, Magtrol In-Line Torque Transducer or auxiliary instrumentation, the DSP6001 both
controls the dynamometer and provides digital readouts on the front panel. The features that make
the DSP6001 unique include:
• TwoChannels-Enablesunittosupportacombinationofuptotwotestinginstrumentswith
independent or tandem configurations.
• Built-InAlarm System -To caution the user whenproblems occur, there areautomatic
electrical and temperature alarms programmed into the unit. Also inherent to the unit are
optional power, speed, torque, air flow, water flow and external input alarms that become
active when enabled by the user.
• Torque/SpeedAnalogOutputs-Abletointerfacewithadataacquisitionsystemorstrip
chart recorder.
• DigitalFilter-Removesundesirednoisefromtorquesignals.
• CrossLoopFunction-Allowsclosedloopcontrolofabrakeviathetorquetransducer.
• Saving-Allowsusertosaveprogrammedvalueswithintheircongurations.
1.1 UNPACKING YOUR DSP6001
Your DSP6001 was packaged carefully for shipping. Please notify your carrier and Magtrol Customer
Service if you believe your unit was damaged in shipping.
1. Save all shipping cartons and packaging material until you inspect the DSP6001.
2. Inspect the DSP6001 for any evidence of damage in shipping.
3. Make sure the carton contains the following:
MODEL DSP6001
DYNAMOMETER CONTROLLER
POWER
POWER
BRAKE STATUS SET POINT SET POINT P I D
TORQUE SPEED STATUS
DECREASE INCREASE
UPDIP
DYNO SETUP SHIFT COM SETUPAUX SETUP
SPEED SET
MAX SPEED
TORQUE SET
TORQUE UNITS
BRAKE ON/OFF
POWER UNITS
DOWN
DSP6001 Dynamometer Controller
Line cord
Magtrol User Manual CD-Rom