User`s manual

3
Magtrol Model DSP6001 Dynamometer Controller
Chapter 1 – Introduction
GENERAL
INFORMATION
2
DSP6001
MAGTROL
Specifications
FRONT PANEL
REAR PANEL
Set Desired Power Units
(W, kW or Hp)
Set Desired Torque Units
(oz.in., oz.ft., lb.in., lb.ft., g.cm, kg.cm, Nmm, Ncm, Nm)
Ready for Rack Mounting
Displays Torque, Speed, Power,
Auxiliary and PID Values
Adjustable PID (Proportional Gain,
Integral and Derivative) settings
provide the best system response
Speed Control
(up to 99,000 rpm)
RS-232 and GPIB/IEEE-488
Interfaces for Connection to PC
For use with any Magtrol Dynamometer
(Hysteresis, Eddy-Current, Powder Brake),
Magtrol Torque Transducer or auxiliary instrumentation
Connectors for Models
DES310/DES311 Power Supplies
(for WB/PB Dynamometers only)
Connector for Model 5241 Power Supply
(for HD-825 Dynamometer only)
Torque/Speed Analog Output for Interfacing with
Data Acquisiton System or Strip Chart Recorder
MEASUREMENT CHARACTERISTICS
Maximum Torque 10,000 units, ±5 V TSC1, ±10 V TSC2
Maximum Speed 99,999 rpm
Accuracy
Speed: 0.01% of reading from 10 rpm to 100,000 rpm
TSC1: 0.02% of range (±1 mV)
TSC2: 0.02% of range (±2 mV)
ELECTRICAL CHARACTERISTICS
Fuses (5 × 20 mm)
Brake: UL/CSA 1.25 A 250 V SB
IEC 1.00 A 250 V T
Power (120 V): UL/CSA 800 mA 250 V SB
Power (240 V): IEC 315 mA 250 V T
Power Requirements 75 VA
Voltage Requirements 120/240 V 60/50 Hz
Max. Compliance Voltage 45 V DC, Brake Output
INPUTS AND OUTPUTS
Maximum Torque Input
TSC1: ±5 V DC
TSC2: ±10 V DC
Accessory
Torque/Speed Output
Torque: ±10 V DC
Speed: ±10 V DC
Ctrl Out 0–3 V DC
ENVIRONMENT
Operating Temperature 5 ºC to 40 ºC
Relative Humidity < 80%
Temperature Coefficient 0.004% of range/°C of 5 V DC for both channels
DIMENSIONS
Width 19.0 in 483 mm
Height 3.5 in 89 mm
Depth
with handles
12.4 in
13.8 in
315 mm
351 mm
Weight 16.73 lb 7.58 kg