User`s manual

9
Magtrol Model DSP6001 Dynamometer Controller
Chapter 2 – Controls
GENERAL
INFORMATION
2. Press any control button to enable the function shown in blue letters above the button.
3. Press the SHIFT button again to exit the secondary function and return to main menu.
Note: If the brake status is ON, the SHIFT button will be ignored.
2.2.2 Enabling Saving Function
To save all current programmed settings:
1. Press the SHIFT button two times. The word “SAVING” will appear in the display, as shown
in Figure 2–3 Saving Function Menu.
POWER
BRAKE STATUS SET POINT SET POINT P I D
TORQUE SPEED STATUS
Figure 2–3 Saving Function Menu
2. After a few seconds, the menu will automatically return to the main menu display and all
configurations of the unit will be saved into a non-volatile memory.
2.2.3 How to uSE Front PanEl controlS and buttonS
2.2.3.1 Controls/Single-Function Buttons
Button To Use Function
POWER Press I to turn power ON Press O
to turn power OFF.
Turns power ON or OFF.
SHIFT Press this button and release; then
press desired control button.
Enables the function written in blue
above control button.
Press this button two times and
release.
Saves current configuration of unit
to non-volatile memory.
UP/LEFT  Press. Increases magnitude of change
when adjusting a numerical value
(speed, torque or max. speed).
DOWN/RIGHT  Press. Decreases magnitude of change
when adjusting a numerical value
(speed, torque or max. speed).
DECREASE /
INCREASE DIAL
Turn clockwise or
counterclockwise.
Increases or decreases the
parameter selected.