User`s manual

10
Magtrol Model DSP6001 Dynamometer ControllerChapter 2 – Controls
GENERAL
INFORMATION
2.2.3.2 Double-Function Buttons
Button To Use Function
POWER UNITS Press SHIFT and release; then
press this button.
Sets desired unit of power. Press
UP  or DOWN  button to see
options. Press SHIFT to enable
option.
BRAKE ON/OFF Press this button. Turns brake ON or OFF.
TORQUE UNITS Press SHIFT and release; then
press this button.
Sets desired unit of measure.
Press UP  or DOWN  button
to see options. Press SHIFT to
enable option.
TORQUE SET Press this button. Enables adjustment of set point for
torque loading.
Press and hold this button until
second beep.
Enables Open Loop mode (if brake
is off).
MAX SPEED Press SHIFT and release; then
press this button.
Sets the speed range of the
Controller.
SPEED SET Press this button. Enables adjustment of set point for
speed loading.
AUX SETUP Press SHIFT and release; then
press this button.
Turns auxiliary/torque transducer
display ON or OFF. Enables
adjustment of scale factors for
torque and speed DAC’S.
P Press this button. Enables adjustment of proportional
term.
COM SETUP Press SHIFT and release; then
press this button.
Adjusts GPIB primary address and
RS-232 baud rate. Also adjusts
display contrast.
I Press this button. Enables adjustment of integral
term.
DYNO SETUP Press SHIFT and release; then
press this button.
Provides options to set maximum
power, dynamometer settings
(input units, maximum torque and
scale factor), speed encoders and
alarms.
D Press this button. Enables adjustment of derivative
term.
2.3 VACUUM FLUORESCENT DISPLAY (VFD)
The VFD provides information about the control functions, the motor under test, and an auxiliary
input device or In-Line Torque Transducer (if connected). The displays, from left to right, are:
Top Row Bottom Row
POWER BRAKE STATUS (ON or OFF)
TORQUE SET POINT (TORQUE)
SPEED SET POINT (SPEED)
AUX INPUT, TM2XX or
STATUS DISPLAY
P
I
D