User`s manual

16
Magtrol Model DSP6001 Dynamometer ControllerChapter 3 – Installation/Configuration
SETUP
3.1.2 SeLf-teSt
After turning the power on to the DSP6001, the display panel will show all segments of the VFD
(series of rectangles), indicating that the DSP6001 is downloading the program.
POWER
BRAKE STATUS SET POINT SET POINT P I D
TORQUE SPEED STATUS
Figure 3–2 Program Download Display
When the program download is complete, the message “MAGTROL MODEL DSP6001 Revision
X.X” appears.
POWER
BRAKE STATUS SET POINT SET POINT P I D
TORQUE SPEED STATUS
Figure 3–3 Revision Display
If the alarms are disabled, the following display message will appear at this time.
POWER
BRAKE STATUS SET POINT SET POINT P I D
TORQUE SPEED STATUS
Figure 3–4 Alarm Warning Display
To activate the alarms, refer to Section 6.1.2.1 – How to Enable/Disable Alarms.
3.1.3 Main MenU
When the DSP6001 is completely powered up and ready for use, the main menu will appear on the
display.
POWER
BRAKE STATUS SET POINT SET POINT P I D
TORQUE SPEED STATUS
Figure 3–5 Main Menu