User`s manual

18
Magtrol Model DSP6001 Dynamometer ControllerChapter 3 – Installation/Configuration
SETUP
3.2.1 DynaMoMeter ConfigUration MenU
To reach the dynamometer configuration menu:
1. Turn on DSP6001 power. See Section 3.1 – Powering Up the DSP6001.
2. Press SHIFT. The word “SHIFT” will appear in the display.
3. Press the DYNO SETUP button. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT P I D
TORQUE SPEED STATUS
↓ ↓ ↓ ↓
Figure 3–6 Dyno Setup Menu
4. Select DYNAMOMETER. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT P I D
TORQUE SPEED STATUS
Figure 3–7 Dynamometer Configuration Menu
5. Pressing the POWER UNITS button allows selection of the preferred testing device (HD,
WB, PB or BRAKE) for TSC1. Pressing the MAX SPEED button allows selection of the
preferred testing device (AUX, WB, PB or TM2XX) for TSC2. Refer to the remainder of
this chapter for more detailed instructions on setup and configuration of the different testing
devices.
Note: For information on Filters, see Chapter 4 – Digital Filters.