User`s manual

ManualsBrandsMagtrol ManualsMusical equipmentDSP6000

Magtrol Model DSP6001 Dynamometer ControllerChapter 3 – Installation/Conﬁguration

SETUP

3.2.6 eDDy-CUrrent or powDer Brake DynaMoMeter SetUp

3.2.6.1 Hardware Connection

DYNAMOMETER / TSC1

AUX / TSC2

SUPPLY 2

SUPPLY 1

RS-232C

GPIB/IEEE–488

BRAKE

ACCESSORY

TORQUE–SPEED

OUTPUT

CTRL OUT

BRAKE FUSE

CAUTION: DOUBLE POLE FUSING

75VA 50/60Hz

EARTH

GROUND

FUSE (5×20mm):

120V UL/CSA 800mA 250V SB

240V IEC 315mA 250V T

(5×20mm):

UL/CSA 1.25A 250V SB

IEC 1A 250V T

MAGTROL, INC. BUFFALO, NY

GPIB

RS-232

M-TEST

Excitation

Torque

TSC 401

Torque-Speed

Conditioner

DES Power Supply

Speed

Eddy-Current (WB)

OR Powder Brake (PB)

Dynamometer

DSP6001 Dynamometer Controller

Figure 3–20 Eddy-Current or Powder Brake Dynamometer Setup

3.2.6.2 Software Conﬁguration

1. Turn on the DSP6001 and proceed to the dynamometer conﬁguration menu. See Section

3.2.1 – Dynamometer Conﬁguration Menu.

2. Select TSC1 until WB or PB is reached.

3. Select TSC2 until AUX is reached.

4. Press SHIFT. The display should appear as follows:

POWER

BRAKE STATUS SET POINT SET POINT P I D

TORQUE SPEED STATUS

Figure 3–21 TSC1 Eddy-Current/Powder Brake Setup Menu

5. Press TORQUE UNITS button and use UP  and DOWN  buttons and Decrease/Increase

dial to set desired scale factor.

6.a. If using an Eddy Current Dynamometer, press SHIFT 2 times. The display should appear

as shown in Figure 3–19 Nominal Speed Setup Menu. Press the AUX SETUP button and

use UP  and DOWN  buttons and Decrease/Increase dial to set desired nominal speed.

Press SHIFT 4 times to complete the initial setup and return to the main menu.

6.b. If using a Powder Brake Dynamometer, press SHIFT 4 times to complete the initial setup

and return to the main menu.