User`s manual

32
Magtrol Model DSP6001 Dynamometer ControllerChapter 3 – Installation/Configuration
SETUP
3.2.10.2 Software Configuration
1. Turn on the DSP6001 and proceed to the dynamometer configuration menu. See Section
3.2.1 – Dynamometer Configuration Menu.
2. Select TSC1 until WB or PB is reached.
3. Select TSC2 until WB or PB is reached.
4. Press SHIFT to get to the TSC1 eddy-current/powder brake setup menu. See Figure 3–21
TSC1 Eddy-Current/Powder Brake Setup Menu.
5. Press TORQUE UNITS button and use UP  and DOWN  buttons and Decrease/Increase
dial to set desired scale factor for TSC1.
6.a. If using an Eddy Current Dynamometer, press SHIFT 2 times. The display should appear
as shown in Figure 3 –19 Nominal Speed Setup Menu. Press the AUX SETUP button and
use UP  and DOWN  buttons and Decrease/Increase dial to set desired nominal speed.
Press SHIFT 2 times to get to the TSC2 Eddy-Current/Powder Brake Setup Menu as shown
in Figure 3–18.
6.b. If using a Powder Brake Dynamometer, press SHIFT 2 times to get to the TSC2 Eddy-
Current/Powder Brake Setup Menu as shown in Figure 3–18.
7. Press TORQUE UNITS button and use UP  and DOWN  buttons and Decrease/Increase
dial to set desired scale factor for TSC2.
8.a. If using an Eddy Current Dynamometer, press SHIFT 2 times. The display should appear
as shown in Figure 3–19 Nominal Speed Setup Menu. Press the AUX SETUP button and
use UP  and DOWN  buttons and Decrease/Increase dial to set desired nominal speed.
Press SHIFT 2 times.
8.b. If using a Powder Brake Dynamometer, Press SHIFT 2 times.
9. The Tandem Configuration Menu will appear as shown in Figure 3–25.
10. Press the COM SETUP button until the menu says “YES”.
11. Press SHIFT 2 times to complete the initial setup and return to the main menu.