User`s manual

36
Magtrol Model DSP6001 Dynamometer ControllerChapter 3 – Installation/Configuration
SETUP
8.a. If choosing a Hysteresis or Powder Brake Type, press SHIFT 2 times to complete setup and
return to main menu.
8.b. If choosing an Eddy-Current Brake Type, menu will appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT P I D
TORQUE SPEED STATUS
Figure 3–33 Brake Type Menu (for WB)
Press AUX SETUP button and use UP  and DOWN  buttons and Decrease/Increase
dial to set nominal speed. Then press SHIFT 3 times to complete setup and return to main
menu.
3.3 SPEED ENCODER SETUP
1. Starting from main menu, press SHIFT.
2. Press DYNO SETUP.
3. Select ENCODERS. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT P I D
TORQUE SPEED STATUS
Figure 3–34 Encoder Menu
4. Press TORQUE UNITS button until the desired bit selection for TSC1 is reached.
5. To set bits for TSC2, press POWER UNITS button once, then press TORQUE UNITS button
until the desired bit selection is reached.
6. Press SHIFT 2 times to complete SPEED ENCODER setup and return to the main menu.
3.3.1 Bit ConfigUrationS
Standard bit configurations are as follows:
Test Instrument Encoder
Hysteresis Dynamometer 60 bit*
Eddy-Current Dynamometer 20, 30 and 60 bit*
Powder Brake Dynamometer 20, 30 and 60 bit*
In-Line Torque Transducer 30 and 60 bit
* 600 and 6000 bit also available