User`s manual

Magtrol Model DSP6001 Dynamometer Controller

Chapter 4 – Digital Filters

SETUP

4.2 FILTER SETUP

Note: Filter setup should take place after hardware installation and software conﬁguration

of the chosen testing instruments has been completed. See Chapter

3 – Installation/Conﬁguration.

There are four different Filter settings to choose from including 10 Hz, 25 Hz, 50 Hz and OFF. The

following instructions show how to select the desired Filter for each channel:

1. Starting from the main menu, press SHIFT.

2. Press DYNO SETUP button.

3. Select DYNAMOMETER.

4. Press TORQUE UNITS button until the desired TSC1 Filter setting is reached.

5. Press COM SETUP button until the desired TSC2 Filter setting is reached.

6. Press SHIFT repeatedly until the main menu is reached. The number of times will vary

depending on testing instrument selection.