User`s manual

72
Magtrol Model DSP6001 Dynamometer ControllerChapter 8 – Computer Controlled Operation
OPERATION
8.6.4 SetUp CoMManDS
Command
Code
Function Explanation
AF1# Sets the analog filter for TSC1. Values for # are:
0 = OFF
1 = 10 Hz
2 = 25 Hz
3 = 50 Hz
4 = 3 Hz
AF2# Sets the analog filter for TSC2. Values for # are:
0 = OFF
1 = 10 Hz
2 = 25 Hz
3 = 50 Hz
4 = 3 Hz
BT# Sets the brake type for TSC1. Values for # are:
0 = HD
1 = WB
2 = PB
DIN1# Selects instrument type
connected to TSC1.
Values for # are:
0 = HD
1 = WB
2 = PB
3 = BRAKE
DIN2# Selects instrument type
connected to TSC2.
Values for # are:
0 = AUX
1 = WB
2 = PB
3 = TM2XX
M# Enables or disables front panel
controls.
Values for # are:
0 = disable
1 = enable
NOTE: The brake ON/OFF switch on the front
panel still functions.
NS# Sets nominal speed for WB
Dynamometer.
Range is 0 to 99,999. Setting is applied to
current channel.
R Resets as follows:
• Manual control ON.
• Brake OFF.
Use this command to cancel any previous
commands.
Note: These settings are the power-on default
settings.
SFC# Enables or disables cross loop
function.
Values for # are:
0 = disable
1 = enable
SFT# Enables or disables tandem
function.
Values for # are:
0 = disable
1 = enable
TSC1 Selects TSC1 to be the
channel that the control loop
closes on.
The TSC1 or TSC2 command should be
the first command sent during testing. All
commands thereafter will be applied to that
channel.
TSC2 Selects TSC2 to be the
channel that the control loop
closes on.
TSF1# Sets scale factor for TSC1. Range is 0 to 99,999.
TSF2# Sets scale factor for TSC2. Range is 0 to 99,999.