Specifications

5
Magtrol Model DSP6000 Dynamometer Controller
Chapter 1 - Introduction
VACUUM FLUORESCENT DISPLAY (VFD)
The VFD provides information about the control
functions, the motor under test, and an auxiliary input
device (if connected). The displays, from left to right,
are:
woRpoTwoRmottoB
REWOP
)sttaWropHnidesserpxe(
SUTATSEKARB
)FFOroNO(
EUQROT)EUQROT(TNIOPTES
DEEPS)DEEPS(TNIOPTES
SUTATSroTUPNIXUA
YALPSID
P
I
D
The DSP6000 is shipped with the Contrast setting at
zero (lowest) in order to prolong display life. If it is
necessary to increase the contrast for improved
readability, use the lowest possible setting to achieve
that result. Using a setting higher than necessary may
cause display segments to burn-in over a period of time,
resulting in uneven illumination from segment to
segment.
STATUS DISPLAY MESSAGES
egasseMgninaeM
TFIHS.desserpsawnotubtfihS
XUA
dnadehcattasitinuyrailixuA
.delbane
DEEPSXAM
.MPRrotommumixaM
RORREO/I
morftnessawdnammoctcerrocnI
.retupmoc
STINU
.tnemerusaemfotinueuqroT
QCATSAF
.edomdeeps-hgihniatadgniriuqcA
ETOMER
.delbaneCPaivlortnocetomeR
NWODPMAR
ybdeepsrotomesaerceD
.rotomnodaolgnisaercni
PUPMAR
ybdeepsrotomesaercnI
.rotomnodaolgnisaerced
DISPLAYING DESIRED INFORMATION
Local control:
1. Press SHIFT and release; then press POWER
UNITS to see UNITS displayed.
2. Press UP
! or DOWN " to scroll through
available choices.
3. Press SHIFT to exit.
4. Press SHIFT and release; then press TORQUE
UNITS to see UNITS displayed.
5. Press UP
! or DOWN " to scroll through
options for units.
6. Press SHIFT to exit.
7. Press RECALL to view memory contents; last in =
first out.
8. Press SHIFT to exit.
Remote control:
Refer to “DSP6000 Command Set” in Chapter 4 - The
DSP6000 with a PC for a list of commands recognized
by the DSP6000.
Auxiliary Input:
1. Press SHIFT and release; then press AUX SETUP.
2. Rotate Decrease/Increase Dial to select scale.
3. Press SHIFT to exit.