Specifications

14
Magtrol Model DSP6000 Dynamometer Controller
Chapter 4 - The DSP6000 as a Stand-Alone Unit (Local Control)
6. Press SHIFT.
7. Press UP
! or DOWN " until you see the
desired GPIB address.
8. Press SHIFT.
9. Press UP ! or DOWN " until you see the
desired RS-232 baud rate.
10. Press SHIFT to exit.
SETTING DYNAMOMETER LOAD
1. Press the UNITS DISPLAY button.
2. Use the Decrease/Increase Dial to adjust the current
output to 0%.
3. Use the BRAKE ON/OFF button to turn the brake
ON.
4. Start the motor under test.
5. Use the UP
! and DOWN " buttons and the
Decrease/Increase Dial to adjust the loading on the
motor.
Do not exceed the capabilities of the
dynamometer or the power source in use.
Motors draw very large currents when
held at locked rotor, and overheating may
result. When using open loop current
control, induction motors cannot be
tested beyond breakdown, except at
locked rotor.
USING INTERNAL MEMORY
STORING DATA POINTS
1. Press and release STORE. The VFD will indicate
STORE followed by a number. This indicates the
memory location that contains the data.
2. Continue pressing STORE at each desired point.
RECALLING DATA POINTS
1. Press and release RECALL. The VFD will indicate
RECALL followed by a number. This number
indicates the memory location that is being
displayed. The order of recalled data is LAST IN =
FIRST OUT (LIFO). A "M" also appears to the
right of the SPEED display to let the user know
that the displayed data is from memory and not real
time data.
2. Continue pressing RECALL until all the desired
data is retrieved. Once data has been recalled, it is
lost from internal memory.
EXITING THE MEMORY MODE
1. Press and release SHIFT.
CLEARING THE MEMORY
1. Press and release SHIFT.
2. Then press CLR MEM.