Specifications

18
Magtrol Model DSP6000 Dynamometer ControllerChapter 5 - The DSP6000 with a PC (Remote Control)
Command
Category
Command
Code
Function Explanation
Setup R Resets as follows:
• Manual control ON
• Low data acquisition rate
• Brake OFF
Use this command to cancel any previous
commands.
Note: These settin
g
s are the power-on default
settin
g
s.
Setup UA# Sets auxiliary input scalin
g
to #
This command sets the scalin
g
factor for the
auxiliary input to # units/volt. The ran
g
e is 0.0 to
10000.0. Pro
g
rammed value # is not saved at
power down.
Setup UE# Sets encoder pulse count to
#
This command selects the pulse count option for
speed transducin
g
. The pulse count defaults to
60-bit if out of ran
g
e.
The standard encoder supplied with all Ma
g
trol
Load Cell Dynamometers is 60 pulses/revolution.
Optional 600 and 6000 pulse encoders are
available for low-speed applications.
Codes for pulse count # are:
0 = 60-bit
1 = 600-bit
2 = 6000-bit
Pro
g
rammed value # is not saved at power
down.
Setup UI# Sets dynamometer torque
units to #
Note: For Hp and watts calculations to be
correct, the correct dynamometer torque units
must be specified. Values for # are:
0 = oz.in. 5 = k
g
.cm.
1 = oz.ft. 6 = N.mm.
2 = lb.in. 7 = N.cm.
3 = lb.ft. 8 = N.m.
4 =
g
.cm.
Torque units default to 0 (oz.in.) if out of ran
g
e.
Pro
g
rammed value # is not saved at power
down.
Setup UR# Sets readout torque units to
#
This command sets the torque unit conversion for
the torque readout.
Values for # are:
0 = oz.in. 5 = k
g
.cm.
1 = oz.ft. 6 = N.mm.
2 = lb.in. 7 = N.cm.
3 = lb.ft. 8 = N.m.
4 =
g
.cm.
Torque unit conversion defaults to 0 (oz.in.) if out
of ran
g
e. Pro
g
rammed value # is not saved at
power down.
Speed A Sets max. speed to 2000
RPM
Commands A, B, C, D, E and F# set a speed
ran
g
e for the Controller. One of these commands
must be specified before usin
g
the speed or
ramp mode.
Speed B Sets max. speed to 4000
RPM
Speed
C
Sets max. speed to 8000
RPM