Specifications

3
Magtrol Model DSP6000 Dynamometer Controller Chapter 1 - Introduction
FRONT PANEL
Figure 1. Front Panel
MODEL DSP6000
DYNAMOMETER CONTROLLER
The front panel provides a power switch, eight control
buttons, a Decrease/Increase Dial, and Vacuum
Fluorescent Display (VFD). The front panel controls
and buttons, from left to right, are:
• Power switch
• Six double-function control buttons:
noitcnuFyramirPnoitcnuFyradnoceS
FFO/NOEKARBSTINUREWOP
TESEUQROTSTINUEUQROT
TESDEEPSDEEPSXAM
PPUTESXUA
IPUTESMOC
DPUTESONYD
• Three single-function control buttons:
• SHIFT (to enable secondary functions printed
in blue above control buttons)
• Up/Left arrow
! (scroll up, increase
magnitude)
• Down/Right arrow
" (scroll down,
decrease magnitude)
• Decrease/Increase Dial
NOTE: Refer to the table, “Front Panel
Controls and Buttons” later in
this chapter for further
explanation of button features
and use.
ENABLING SECONDARY FUNCTIONS
To enable the secondary function of the double-function
control buttons:
1. Press the blue SHIFT button and release it. (The
word SHIFT appears in the display.)
2. Press a control button to enable the function shown
in blue letters above the control button:
POWER UNITS, TORQUE UNITS, AUX SETUP,
COM SETUP or DYNO SETUP.
3. Press the SHIFT button again to exit the secondary
function.