User`s manual

42
Magtrol WB/PB DynamometersChapter 2 – Installation / Mounting
2.1.1 WB/PB 2.7 SerieS
Before mounting any WB/PB 2.7 Series Dynamometer to the test bench, the load cell must first be
unlocked. The shipping/restraining pin of the locking system is found on the lower part of the brake.
Proceed as follows and refer to figure 2–1 to unlock the dynamometer:
1. Loosen the fixing screw
.
2. Remove the shipping/restraining pin
, and re-insert it with the thinner part inside.
3. Tighten the screw
.
#OOLINGWATER
INLET


Figure 2–1 WB/PB 2.7 Load Cell Locking System